SIGLENT SDS1000D Manual do Utilizador descarregar pdf (Página 127)

119

3.1Taking Simple Measurements

Observe a unknown signal in a circuit, display the signal quickly and measure

the frequency and peak-to-peak amplitude.

1. Using Auto set

To quickly display a signal, follow these steps:

1. Press the CH1 button, set the Probe option attenuation to 10X and set the

switch to 10X on the probe.

2. Connect the channel 1 probe to the signal.

3. Press the AUTO button.

The oscilloscope sets vertical, horizontal, and trigger controls automatically. If

you want to optimize the display of the waveform,

You can adjust these controls manually till you are satisfied with the

waveforms

2. Taking Automatic Measurements

The oscilloscope can take automatic measurements of most displayed signals.

To measure signal frequency and peak-to-peak amplitude, follow these steps:

(1)Measure signal frequency

●

Input the signal to channel 1.

●

Press the “AUTO” button.

●

Press the “MEASURE” button to see “auto Measure Menu”.

●

Press the top option button.

●

Press the “Time” option button to enter the “Time Measure menu”.

●

Press the “Source” option button to select input signal channel.

●

Press the “Type” option button to select “Freq”

NOTE

. The oscilloscope displays relevant automatic measurements in the

waveform area of the screen based on the signal type detected.

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 153 154

Sem comentários

SIGLENT SDS1000D Manual do Utilizador Página 127